Can’t Access Here’s How to Fix It!

Millions set up Netgear wireless extenders in their homes to access an uninterrupted internet connection. In order tweak the WiFi settings of their extenders, users need to access However, many of them fail miserably while accessing If you are also being welcomed by the not working error message, read this post.

Here, we have sorted some easy methods using which you can easily resolve the ‘can’t access’ issue. So, without any delay, let’s go ahead.

Resolved: Can’t Access

Before you execute the troubleshooting hacks, make sure that your Netgear extender is plugged into a working electrical outlet and the power LED is glowing green. If everything is fine with the electrical outlet and the power LED, then have a look at the following tips to fix the issue you are facing:

1) Reboot the Netgear Extender

Let’s start with the simplest hack i.e rebooting. It may look like a little effort but has proven to be effective in fixing several extender-related issues. The reason being, rebooting the device resolves technical glitches that might be preventing you from accessing

You can reboot your Netgear by switching it off and giving it some time to rest. After giving enough time to your WiFi device, switch it on. Once done, try accessing the login page. If you are still failing to do so, then look at the next troubleshooting tip.

2) Clear Browser’s Cache

You might also be unable to access if the web browser you are using is cached. So, before you access the mywifiext page, it is advised to clear the cache, cookies, and browsing history of the web browser.

An outdated version of the web browser is also one of the reasons behind the ‘can’t access’ issue. So, apart from clearing cache and cookies, you also need to ensure that the web browser is updated.

3) Type in Address Bar

Many users can’t access because they type the web address in the search bar of the web browser. Perhaps, you might have committed the same mistake. Typing the web address in the search bar will bear no result.

Remember that to access the setup wizard, you need to type the web address in the address bar of the web browser.

4) Check the Connection Between WiFi Devices

Another reason why you’re failing to access is because of a weak connection between your Netgear extender and router. So, check whether your WiFi devices are connected properly or not. If you have connected them via a wireless source, then we advise you to use an Ethernet cable instead for a flawless signal transmission.

Just in case you are already using an Ethernet cable, it is time to check for physical damages on it. Replace your Ethernet cable if the one you are currently using is damaged.

5) Change the Extender’s Location

The location of your Netgear extender plays a vital role in its performance. The incorrect location of your WiFi device can also halt your access to So, it is time to move your extender to a new location. Consider the following points while choosing the correct location for your Netgear extender:

● Maintain a clear line of sight between your Netgear range extender and the router.
● Avoid placing your Netgear extender in corners or near concrete walls.
● Do not place your WiFi device inside a closet or under a table. Consider placing it in a well-ventilated area instead.
● Most importantly, select a location away from baby monitors, cordless phones, refrigerators, microwave ovens, Bluetooth speakers, etc.

The Conclusion

Did you get success in accessing after following the aforementioned troubleshooting hacks? No? Don’t worry! You can opt for the ultimate hack, that is, factory default reset of the extender. Post resetting, you need to configure your extender from scratch.

Leave a Reply

Your email address will not be published. Required fields are marked *